The short version of lyophilisation fits in a sentence. The long version — which is the one that helps — is below.
Reviewed 2025-10-28. Anything still debated is marked as such rather than presented as settled.
Identity and purity are usually assessed with reversed-phase high-performance liquid chromatography, often paired with mass spectrometry using electrospray or MALDI ionisation. Amino acid analysis and peptide mapping by enzymatic digestion provide additional sequence-level confirmation. Purity is commonly reported as an area percentage from a chromatographic trace, and water content can be measured by Karl Fischer titration. Reported masses may differ by tens of daltons between sources because preparations can contain acetate or trifluoroacetate counterions, and such differences are not by themselves evidence of a different peptide.
BPC-157 is normally distributed as a lyophilised powder that ranges from white to off-white in appearance. The peptide dissolves readily in water, normal saline, and common aqueous buffers, and it is poorly soluble in nonpolar solvents such as hexane or vegetable oils. Lyophilised vials take up moisture if left open, which changes the mass of powder in the container and complicates any later weighing. Because the material is handled in small quantities, static and adhesion to glass or plastic can also cause noticeable losses during transfer.
The main chemical liabilities of this sequence are peptide-bond hydrolysis and possible aspartate-related reactions, since the peptide contains aspartic acid residues but no cysteine, methionine, or tryptophan. Absence of those three residues removes the most common oxidation and disulfide pathways from consideration. Studies of related peptides indicate that aspartate isomerisation and aspartimide formation occur most readily at Asp-Gly and Asp-Ala positions, and open questions remain about how quickly those reactions proceed under ordinary laboratory conditions. Storage guidance typically emphasises cool, dry, dark conditions to slow hydrolysis.
The peptide was first described in the early 1990s by a group studying gastric secretions and tissue repair. Its fifteen-residue chain is usually written as GEPPPGKPADDAGLV in single-letter code. The free peptide has the formula C62H98N16O22 and a theoretical mass near 1419.5 daltons. These identifiers are established chemical facts that can be checked against standard peptide databases. There is no ambiguity about the primary structure.
Most published findings come from rodent experiments using induced injury or surgical models. Human reports remain scarce and are largely observational, which limits how much can be stated with confidence. Questions about absorption, distribution, metabolism, and clearance in people are still open. Dose translation between species is likewise unresolved. Researchers tend to read the animal literature as a starting point rather than a settled account.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white powder | Lyophilised material; shade varies slightly between lots |
| Solubility in water | Freely soluble | Dissolves in water, saline, and aqueous buffers |
| Solubility in nonpolar solvents | Poorly soluble | Not compatible with oils or hydrocarbon solvents |
| Typical storage temperature | About −20 °C | Lyophilised, dry, dark storage slows hydrolysis |
| Common purity method | Reversed-phase HPLC | Area percentage, usually paired with mass spectrometry |
BPC-157 is a synthetic peptide built from fifteen amino acid residues. Its sequence comes from a larger protein fragment that researchers isolated from human gastric juice and described as a body protection compound. The fragment contains glycine, glutamic acid, five prolines, lysine, alanine, two aspartic acids, leucine, and valine. The number 157 in the name refers to the position of the stretch within the parent protein. Material used in laboratories is manufactured rather than extracted from stomach fluid.
The molecule carries 15 residues, a molar mass near 1419.5 g/mol, and the formula C62H98N16O22. Its structure features a proline-rich central region, a pair of adjacent aspartic acid residues, and no cysteine. The absence of cysteine means no disulfide bonds can form, which simplifies refolding and reconstitution. Suppliers usually ship the material as a freeze-dried powder that appears white to off-white. It dissolves readily in water and in saline solutions.
Long-term storage of the dry powder is typically described at minus twenty degrees Celsius or colder, while shorter holding periods may use ordinary refrigeration. Repeated warming and cooling cycles are discouraged because they stress the material and can promote aggregation or loss. Light exposure and residual moisture are both treated as avoidable sources of degradation, and working aliquots are often prepared to limit how many times a container is opened. Sealed vials with a desiccant are the usual container.
Quality assessment rests on two separate questions: whether the chain is the intended one, and how much of the sample is that chain. Reverse-phase high-performance liquid chromatography with ultraviolet detection is the standard purity measurement, while mass spectrometry confirms identity through the observed molecular mass. Amino acid analysis and sequence verification provide further checks. A reported purity percentage describes the proportion of the sample represented by the main peak, not the amount of peptide by mass, since counter-ions and water make up part of any lyophilized lot.
In its usual supplied form, the peptide is a white to off-white lyophilized powder that dissolves readily in water and in aqueous buffers. Powder keeps far longer than solution, so material is normally shipped and stored dry, then dissolved only when needed. Once in solution, the chain is subject to hydrolysis and the liquid supports microbial growth, and practical guidance generally treats the dissolved form as short-lived. Containers should stay sealed and desiccated, because the powder takes up moisture from air.
Epitiostanol, sold under the brand name Thiodrol, is an injected antiestrogen and anabolic–androgenic steroid (AAS) of the dihydrotestosterone (DHT) group which was described in the literature in 1965 and has been marketed in Japan as an antineoplastic agent for the treatment of breast cancer since 1977.
Pentobarbital is a short-acting barbiturate typically used as a sedative, a preanesthetic, and to control convulsions in emergencies. It can also be used for short-term treatment of insomnia but has been largely replaced by the benzodiazepine family of drugs. In high doses, pentobarbital causes death by respiratory arrest. It is frequently used for veterinary euthanasia, and is used by some US states and the United States federal government for executions by lethal injection. In some countries and states, it is also used for physician-assisted suicide. Pentobarbital was developed by Ernest H. Volwiler and Donalee L. Tabern at Abbott Laboratories in 1930. The drug was widely abused beginning in the late 1930s, and it is sometimes known as "yellow jackets" due to the yellow color of Nembutal-branded capsules.
In March 2014, the IOC Disciplinary Commission decided that Bäckström would be awarded the silver medal. In January 2015 Bäckström, the IOC, WADA and the IIHF agreed to a settlement in which he accepted a reprimand but was cleared of attempting to enhance his performance.
The cause of the 2006 death of Alexander Litvinenko, a former Russian FSB agent who had defected to the United Kingdom in 2001, was identified to be poisoning with a lethal dose of 210Po; it was subsequently determined that the 210Po had probably been deliberately administered to him by two Russian ex-security agents, Andrey Lugovoy and Dmitry Kovtun. As such, Litvinenko's death was the first (and, to date, only) confirmed instance in which polonium's extreme toxicity has been used with malicious intent. In 2011, an allegation surfaced that the death of Palestinian leader Yasser Arafat, who died on 11 November 2004 of uncertain causes, also resulted from deliberate polonium poisoning, and in July 2012, concentrations of 210Po many times more than normal were detected in Arafat's clothes and personal belongings by the Institut de Radiophysique in Lausanne, Switzerland. Even though Arafat's symptoms were acute gastroenteritis with diarrhoea and vomiting, the institute's spokesman said that despite the tests the symptoms described in Arafat's medical reports were not consistent with 210Po poisoning, and conclusions could not be drawn. In 2013 the team found levels of polonium in Arafat's ribs and pelvis 18 to 36 times the average, even though by this point in time the amount had diminished by a factor of 2 million. Forensic scientist Dave Barclay stated, "In my opinion, it is absolutely certain that the cause of his illness was polonium poisoning. ...
Sources: en.wikipedia.org
== Locations == The company's headquarters remain in Parkville, Victoria, an inner suburb of Melbourne, and has offices and laboratory space in Sydney. CSL Behring is headquartered in King of Prussia, USA and it has manufacturing operations and R&D laboratories in Broadmeadows, Victoria, the Swiss city of Bern, in Marburg in Germany, and Kankakee, USA. Seqirus has its headquarters in Maidenhead and has production facilities in Holly Springs, US, Liverpool, UK, and Parkville, Victoria
=== Breakdown of biopolymers === Biopolymers like cellulose, lignin, chitin, or starch may be broken down into their individual nanoscale building blocks, obtaining anisotropic fiber- or needle-like nanoparticles. The biopolymers are disintegrated mechanically in combination with chemical oxidation or enzymatic treatment to promote breakup, or hydrolysed using acid.
== Peptides and proteins == A number of algorithms for estimating isoelectric points of peptides and proteins have been developed. Most of them use Henderson–Hasselbalch equation with different pK values. For instance, within the model proposed by Bjellqvist and co-workers, the pKs were determined between closely related immobilines by focusing the same sample in overlapping pH gradients. Some improvements in the methodology (especially in the determination of the pK values for modified amino acids) have been also proposed. More advanced methods take into account the effect of adjacent amino acids ±3 residues away from a charged aspartic or glutamic acid, the effects on free C terminus, as well as they apply a correction term to the corresponding pK values using genetic algorithm. Other recent approaches are based on a support vector machine algorithm and pKa optimization against experimentally known protein/peptide isoelectric points. Moreover, experimentally measured isoelectric point of proteins were aggregated into the databases. Recently, a database of isoelectric points for all proteins predicted using most of the available methods had been also developed. In practice, a protein with an excess of basic aminoacids (arginine, lysine and/or histidine) will bear an isoelectric point roughly greater than 7 (basic), while a protein with an excess of acidic aminoacids (aspartic acid and/or glutamic acid) will often have an isoelectric point lower than 7 (acidic).
Sources: en.wikipedia.org
=== Encoding === Methionine is one of only two amino acids encoded by a single codon (AUG) in the standard genetic code (tryptophan, encoded by UGG, is the other). In reflection to the evolutionary origin of its codon, the other AUN codons encode isoleucine, which is also a hydrophobic amino acid. In the mitochondrial genome of several organisms, including metazoa and yeast, the codon AUA also encodes for methionine. In the standard genetic code AUA codes for isoleucine and the respective tRNA (ileX in Escherichia coli) uses the unusual base lysidine (bacteria) or agmatidine (archaea) to discriminate against AUG. The methionine codon AUG is also the most common start codon. A "Start" codon is message for a ribosome that signals the initiation of protein translation from mRNA when the AUG codon is in a Kozak consensus sequence. As a consequence, methionine is often incorporated into the N-terminal position of proteins in eukaryotes and archaea during translation, although it can be removed by post-translational modification. In bacteria, the derivative N-formylmethionine is used as the initial amino acid.
According to the International Programme on Chemical Safety (IPCS) and the U.S. Food and Drug Administration (FDA), amphetamine is contraindicated in people with a history of drug abuse, cardiovascular disease, severe agitation, or severe anxiety. It is also contraindicated in individuals with advanced arteriosclerosis (hardening of the arteries), glaucoma (increased eye pressure), hyperthyroidism (excessive production of thyroid hormone), or moderate to severe hypertension. These agencies indicate that people who have experienced allergic reactions to other stimulants or who are taking monoamine oxidase inhibitors (MAOIs) should not take amphetamine, although safe concurrent use of amphetamine and monoamine oxidase inhibitors has been documented. These agencies also state that anyone with anorexia nervosa, bipolar disorder, depression, hypertension, liver or kidney problems, mania, psychosis, Raynaud's phenomenon, seizures, thyroid problems, tics, or Tourette syndrome should monitor their symptoms while taking amphetamine. Evidence from human studies indicates that therapeutic amphetamine use does not cause developmental abnormalities in the fetus or newborns (i.e., it is not a human teratogen), but amphetamine abuse does pose risks to the fetus. Amphetamine has also been shown to pass into breast milk, so the IPCS and the FDA advise mothers to avoid breastfeeding when using it. Due to the potential for reversible growth impairments, the FDA advises monitoring the height and weight of children and adolescents prescribed an amphetamine pharmaceutical.
In reductive soil and sediments, PCP can be degraded within 14 days to 5 years, depending on the anaerobic soil bacteria that are present. However, adsorption of PCP in soils is pH dependent because it increases under acidic conditions and decreases in neutral and basic conditions.
Caffeine from coffee or other beverages is absorbed by the small intestine within 45 minutes of ingestion and distributed throughout all bodily tissues. Peak blood concentration is reached within 1–2 hours. It is eliminated by first-order kinetics. Caffeine can also be absorbed rectally, evidenced by suppositories of ergotamine tartrate and caffeine (for the relief of migraine) and of chlorobutanol and caffeine (for the treatment of hyperemesis). However, rectal absorption is less efficient than oral: the maximum concentration (Cmax) and total amount absorbed (AUC) are both about 30% (i.e., 1/3.5) of the oral amounts. Caffeine's biological half-life – the time required for the body to eliminate one-half of a dose – varies widely among individuals according to factors such as pregnancy, other drugs, liver enzyme function level (needed for caffeine metabolism) and age. In healthy adults, caffeine's half-life is between 3 and 7 hours. The half-life is decreased by 30–50% in adult male smokers, approximately doubled in women taking oral contraceptives, and prolonged in the last trimester of pregnancy. In newborns the half-life can be 80 hours or more, dropping rapidly with age, possibly to less than the adult value by age 6 months. The antidepressant fluvoxamine (Luvox) reduces the clearance of caffeine by more than 90%, and increases its elimination half-life more than tenfold, from 4.9 hours to 56 hours.
Sources: en.wikipedia.org
Lyophilised peptide powders are generally kept frozen or refrigerated, dry, and protected from light. Sealed vials limit moisture uptake and slow hydrolysis. Such guidance comes from general peptide chemistry rather than from stability studies specific to every product.
Reversed-phase HPLC is the standard approach, with purity expressed as a percentage of total peak area. Mass spectrometry confirms the expected molecular mass and can reveal adducts or truncated sequences. Neither method on its own establishes biological activity.
Small mass differences often reflect different counterions, such as acetate versus trifluoroacetate, or bound water rather than a different amino acid sequence. Mass spectrometry can distinguish these forms when the ionisation conditions are known. Exact sequence confirmation requires peptide mapping or tandem mass spectrometry.
The peptide is synthetic, but its sequence matches a segment of a protein present in human gastric juice. It does not occur as a free fifteen-residue peptide in the body.